Connect Peripheral Equipment; Connecting And Selecting Equipment; Side Connections - Philips 28PW9528 Manual

Connect Peripheral Equipment

There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note: can handle CVBS and RGB,
EXT. 1
connect peripherals with RGB output to
If your recorder is provided with the EasyLink function, it should be connected to
EasyLink functionality.
Recorder ( -
VCR
CABLE
2
EXT.
1
2
4
Other equipment
CABLE
1
4
2

Side connections

1 2 3
20
EXT. 2
EXT. 1
+ )
DVD RW
Connect the aerial cables 1, 2 and, to obtain the optimum
picture quality, eurocable 3 as shown.
If your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorder's test signal and assign it programme number 0 or
store the test signal under a programme number between 90 and
99, see Manual installation, p. 6.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook.
See Decoder, p. 9 You can also connect your decoder directly to
EXT. 1
(satellite receiver, decoder, DVD, games, etc.)
&
1
EXT.
2
é
5
3 "
Camera or Camcorder
&
é
&
é
CVBS and Y/C,
or as RGB provides a better picture quality.
3
or with a eurocable.
2
Connect the aerial cables 1, 2 and 3 as shown (only if
your peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to one of
the euroconnectors
EXT.1
quality.
Look for the test signal of your peripheral in the same way as
you do for a recorder.
Make a selection in the Setup, Source menu, p. 10.
Connect your camera or camcorder as shown.
2 and
Connect to
VIDEO
equipment. For stereo equipment also connect
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the S-video input
audio inputs 3.
Do not connect cable 1 and 2 at the same time. This may cause
picture distortion !
Headphone
Insert the plug into the headphone socket L as shown.
Press ¬ on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm. The
headphone socket has a 3.5 mm jack.
In the Sound menu select
headphone volume.
CVBS and RGB. It is preferred to
EXT. 3
EXT. 2
, or to obtain a better picture
2 3
3 for mono
AUDIO L
Headphone volume
to benefit from the
3.
AUDIO R
1
and
to adjust the