Advertisement
Quick Links
FTI-CDP1 - Vehicle Coverage and Preparation Notes
Make
Model
DL-CH8
RAM
3500 TIP Start Diesel
Firmware: Covered vehicles use either BLADE-AL(DL)-CH8, confirm application, flash module, and update the controller
firmware before installing.
Install: Type 2 vehicles use the included CAN extension cable to source CAN data from the green CAN junction block
(left side of the dash) or from the BCM (pin#25, CANH, brown, pin #26, CANL, yellow).
Lighting: Type B parking lights use the 10-pin connector, secure unused 6-pin connector for safety.
Ignition: Common ignition provisions are listed in the BLADE diagram, ignition is also available at the vehicle BCM
(connector C5/E, pin #27, pink/white).
Hood: Hood status wire is available at the vehicle BCM, connector C1, pin #11 (violet/blue).
FTI-CDP1 - Installation and Configuration Notes
Required CAN connections.
A
Not required.
B
Vehicle hood status ( - ).
C
Ignition jumper, NO CONNECTION required.
D
Ignition connection.
E
Year
2018
CONNECT TO PINK.
BLADE FEATURE COVERAGE
Install
CAN
Lights
Park / Auto
Type 2
CJB
Type B
IGN
Hood
I/O Changes
Green White/Blue
BCM
BCM
CM7000/7200
Cut loop for A/T
CM-900S/900AS
CM900AS/900S Jumper
Advertisement
Related Manuals for Firstech BLADE Series
Summary of Contents for Firstech BLADE Series
- Page 1 FTI-CDP1 - Vehicle Coverage and Preparation Notes Make Model Year Install Lights Hood I/O Changes DL-CH8 Park / Auto Green White/Blue 3500 TIP Start Diesel 2018 Type 2 Type B Firmware: Covered vehicles use either BLADE-AL(DL)-CH8, confirm application, flash module, and update the controller firmware before installing.
- Page 2 2018 RAM 3500 TIP Start Diesel FTI-CDP1 - DL-CH8 - Type 2 Diesel WTS BLADE Techfeedtree Set feature option 4-10-4 OBD-II connector TIP Start Cylinder Headlight switch Type B *Not required Green Junction Block C5 - Ignition Driver side dash 26 25 26 25 brown...
- Page 3 ALL IN ONE INSTALL GUIDE DODGE/RAM Patent No. US 8,856,780 CA 2759622 COM-BLADE-AL(DL)-CH8-EN 20191004 Doc. No.: ##65995## MODULE PROGRAMMING PROCEDURE - WITH KLON Close driver door. Turn key to OFF position. Re-open driver door to wake up WARNING: data bus. Disconnect power last.
- Page 4 ALL IN ONE INSTALL GUIDE DODGE/RAM Patent No. US 8,856,780 CA 2759622 COM-BLADE-AL(DL)-CH8-EN 20191004 Doc. No.: ##65995## WARNING: READ BEFORE REMOTE STARTING THE VEHICLE NOTICE IMPORTANT All vehicle doors must be closed and locked prior to remote start sequence. Failure to comply will result in remote starter malfunction. TAKE OVER PROCEDURE - TO THE VEHICLE OWNER TIME RESTRICTI N NOTE...