Charging - Porsche Mobile Charger Connect Owner's Manual

Charging

Notes on charging
Vehicle charge port
For information on connecting and disconnecting the
vehicle cable to and from the vehicle charge port and
for the charging and connection status at the vehicle
charge port:
g See Owner's Manual.
Electric shock, fire
DANGER
Risk of serious or fatal injury due to fire or electric
shock.
e
Always observe the specified sequence for the
charging process.
e
Do not disconnect the vehicle cable from the
vehicle charge port during the charging process.
e
End the charging process before disconnecting
the vehicle cable from the vehicle charge port.
e
Do not disconnect the charger from the electrical
socket during the charging process.
Errors are shown on the display and are indicated by
red status LEDs. The error message, the cause and a
remedial measure will be displayed.
e
Refer to chapter "Malfunctions" on page 29.
Charging times
The charging duration can vary depending on the
following factors:
–
Electrical socket used (domestic electrical outlet
or industrial electrical outlet)
–
Country-specific power grid voltage and current
–
Settings for limiting the charging current on the
charger
–
Fluctuations in the grid voltage
–
Ambient temperature of vehicle and charger.
Charging times can be longer at temperatures at
the upper and lower extremes of the permitted
ambient temperature.
g Refer to chapter "Deactivating and activating
ground monitoring" on page 20.
– Temperature of the high-voltage battery and
control unit
– Passenger compartment precooling/heating ac-
tivated
–
Current-carrying capacity of the power plug and
vehicle plug
Information
Due to different national power grid systems, various
cable variants are available. This may result in the
full charging performance not being available. Further
information is available from your authorized Porsche
dealer.
Starting, pausing and stopping charg-
ing
Starting charging
1. Insert the plug into the electrical socket.
Power button lights up white.
Status LEDs light up white.
�� The display turns on.
2. Insert the vehicle plug in the vehicle charge port.
Power button lights up white.
Status LEDs pulsate white.
For information on connecting the vehicle cable
to the vehicle charge port:
g See Owner's Manual.
�� Following a successful self-test and when
the connection is established, the status
LEDs light up white.
3. Charging starts automatically.
Power button lights up white.
Status LEDs pulsate green.
4. After a few minutes, the display switches to
standby mode.
�� The vehicle is charging.
Information
− Charging is controlled by the vehicle. The charg-
ing process can only be stopped at the vehicle.
− The charge status is shown on the display pro-
vided the charger is not in standby mode. The
display can be switched on again by pressing the
Power button .
−
A high-temperature switch-off feature prevents
overheating while charging.
Pausing charging
Charging is controlled by the vehicle and may occa-
sionally be paused, e.g. in order to optimize power
consumption.
When charging is paused, this will be indicated on
the control unit:
– Power button lights up white.
Status LEDs flash blue.
The display turns on.
The vehicle starts charging again automatically. The
charging process can be stopped at the vehicle.
Operating
19