Advertisement
OPERATING SHRED-N-VAC™
WARNING A DANGER
• Always wear safety glasses and use a face
filter mask. (Read the Safety Section
carefully.)
IMPORTANT
Do not block vacuum pipe to avoid engine damage
due to over revving.
1.
Allow the engine to warm up at a fast idle for
a few minutes.
NOTE
The ECHO SHRED-N-VAC™ can be run at any
speed between 2500 RPM to 7000 RPM. The
vacuum can, therefore, be easily controlled from a
mild vacuum for small leaves to maximum suction
for larger leaves and twigs. For maximum shredding
a higher speed setting is required.
NOTE
Never use a higher speed setting than necessary to
perform a task. Remember, the higher the engine
speed, the louder the vacuum noise.
2.
Set engine speed with throttle position knob.
3.
Place shoulder harness over right shoulder.
4w
4.
Make sure bevel at end of pipe faces downward.
OPERATING BLOWER
WARNING
A
DANGER
• Always wear safety glasses and use a face filter
mask. (Read the Safety Section carefully.)
• Do not point the blower pipe in the direction of
people or pets.
• Never operate unit without housing cover grill
secured by thumb nut otherwise bodily harm
may result.
IMPORTANT
Do not block blower pipe to avoid engine damage
due to over revving.
1.
Allow the engine to warm up at a fast idle for
a few minutes.
2.
Set engine speed with throttle position knob.
NOTE
'
"
The ECHO SHRED-N-VAC™ can be run at any speec
between 2500 RPM to 7000 RPM. The velocity of the
air stream can, therefore, be easily controlled from a
mild flow to high speed blast which will move debris
ranging from garden leaves to bottles and other
debris.
NOTE
Never use a higher speed setting than necessary to
perform a task. Remember, the higher the engine
speed, the louder the blower noise.
NOTE
Use a low speed to blow dry leaves from a lawn or
flower bed. Additional speed may be necessary to
clean grass and leaves from walks, patios and drives
or to move gravel, dirt, snow, bottles or cans from a
driveway, street or parking lot.
6
Advertisement
