Advertisement
ASSEMBLY
WARNING
A
DANGER
Never perform maintenance or assembly
procedures with engine running.
IMPORTANT
Never operate unit without either housing over
or vacuum tube installed securely on unit.
INSTALLING VACUUM TUBE
1. Turn knob (A) counterclockwise until housing
cover is free. Pull fan guard out for access
to tube clamp (B).
NOTE
The tube will contact the switch tab when
properly assembled onto the blower. A "click"
will be heard indicating the switch is activated
allowing the unit to operate. If the engine does
not start, recheck the tube mounting for
straightness and engagement with the blower
housing.
2. Hold the housing cover open, and slide the
vacuum tube into the housing mount until
completely seated. Position the tube so that
the bevel faces down in the operating
position.
WARNING
A
DANGER
This unit Is equipped with a safety switch
(C) which allows the engine to start or run
only when the fan guard Is In place or the
vacuum tube is Installed. Never bend or
disable this switch and opetate the unit;
otherwise severe injury may result.
3. Secure vacuum tube with clamp (B).
Note: Make sure that the clamp fits under the
slotted guide.
4. Align grooves in vacuum elbow with pegs on
air outlet and install vacuum elbow.
5. Turn vacuum elbow clockwise to lock it into
place.
6. Place vacuum bag opening over end of
vacuum elbow and secure with velcro straps.
INSTALLING BLOWER PIPES
WARNING
A
DANGER
Never perform maintenance or assembly
procedures with engine running.
1 •
Align grooves in straight pipe with pegs on
blower housing and slide pipe onto
housing.
2.
Turn straight pipe clockwise to lock it into
place.
3.
Align grooves in fan head nozzle with pegs
on straight pipe and slide fan head nozzle
onto straight pipe.
4.
Turn fan head nozzle clockwise to lock it into
place.
11
Advertisement
