Advertisement
OPERATION
IMPORTANT
Recoil starter: Use short pulls - only 1/2-2/3
of starter rope for starting. Do not allow the
rope to snap back in. Always hold the unit
firmly.
IMPORTANT
• Check unit for loose nuts, bolts and screws
daily.
STARTING COLD ENGINE
1. Move ignition switch to START/RUN position.
2. Push purge bulb 3 to 4 times (or until fuel is
visible in fuel return line).
3. Close choke and pull starter handle until
engine fires.-
:r
STARTING WARM ENGINE
1. Move ignition switch to start, pull starter one
to three times and engine should fire. Do not
use choke.
STOPPING ENGINE
1. Release throttle trigger and allow engine to run
at idle for a few minutes.
2. Move ignition switch to "stop" position.
If engine does not stop, shift choke lever
to closed position.
Check and repair ignition switch before
starting engine again.
Advertisement
