York ZF210 Instruction Manual page 69

Fan operates with proper rotation
Pressure drop across dry evaporator coil (At maximum design CFM)
External Static Pressure
Return Static Pressure
Supply Static Pressure
Supply Air CFM Using Dry Coil Chart
Final Adjusted Supply Air CFM
1. Consult the proper airflow to pressure drop table to obtain the actual airflow at the measured pressure differential.
2. Was a motor pulley adjustment or change required to obtain the correct airflow?
Was it necessary to increase of decrease the airflow to meet the design conditions?
If the motor pulley size was changed, measure the outside diameters of the motor and blower pulleys and record those diameters here;
Blower Motor HP _______________________________FLA________ RPM________
Pulley Pitch Diameter ______________Turns Out________ Final Turns Out________
Blower Pulley Pitch Diameter ________________ Fixed Sheave_________________
T1 - T2 ____________________________ Volts
Control Voltage ______________________ Volts
Device
1, 2
Supply Fan Motor
Exhaust Motor (Dampers 100%)
Condenser Fan #1
Condenser Fan #2 (if equipped)
Condenser Fan #3 (if equipped)
Condenser Fan #4 (if equipped)
Compressor #1
Compressor #2 (if equipped)
Compressor #3 (if equipped)
Compressor #4 (if equipped)
1. VAV units with heat section - simulate heat call to drive VAV boxes and VFD/IGV to maximum design airflow position.
2. VAV units without heat section - VAV boxes must be set to maximum design airflow position.
4
Johnson Controls Unitary Products
Operating Measurements - Air Flow
2
ELECTRICAL DATA
Nameplate
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
ID Fans Exh. Fans
1
T2 - T3 ____________________________ Volts
T1 - T3 ____________________________ Volts
Measured
List All Three Amperages
1088917-YIM-B-1014
1034349-UCL-B-0814
Cond. Fans
IWC
IWC
IWC
IWC
CFM
CFM
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
AMPS
Unitary Products Group
69