Table of Contents
Advertisement
3
Press the Delay End button as necessary.
4
Press the Start/Pause button.
NOTE
• Except for LED of the Delay End button, all LEDs
on the control panel will be turned off within 20
minutes. This feature may vary depending on
the model purchased.
• The delay time is the time to the end of the
programme, not the start. The actual running
time may vary due to water temperature, clothes
and other factors.
• To cancel the function, the Power button should
be pressed.
• Avoid using liquid detergent for this function.
Using the ezDispense
Use the Dispenser 1 and Dispenser 2 buttons to
set up and control the ezDispense function.
a
Dispenser 1 button
b
Dispenser 2 button
c
Buttons indicator
Liquid detergent indicator
d
Link indicator (Using only liquid detergent both
e
compartments)
Buttons indicator
f
Liquid fabric softener indicator
g
NOTE
• Whether the detergent or softener indicator may
blink and the chime may sound, even if there is
sufficient detergent or softener left to use for
approximately 2 to 4 washing programmes;
- If the liquid detergent indicator
buttons indicator
sounds, pour the detergent into the
compartment, up to the MAX line.
- If the liquid fabric softener indicator
buttons indicator
sounds, pour the fabric softener into the
compartment, up to the MAX line.
• The default settings are configured to dispense
the detergent of Dispenser 1 and the fabric
softener of Dispenser 2.
Changing Dispense Level for a Single
Load
1
Press the Power button.
2
Turn the knob to select the desired cycle.
3
Press the Dispenser 1 or Dispenser 2 button
to increase or decrease the dispensed amount
from the set defaults.
Buttons Indicator
OPERATION
and
d
,
blink and the chime
c
f
and
g
blink and the chime
f
Dispensed Amount
More (110%)
Medium (100%)
Less (90%)
35
*1
Advertisement
Table of Contents
