Cable Box Setup.15 - Panasonic OmniVision PV-V4020 Operating Instructions Manual

'Important: If the remote control POWER, ACTION, PROGA/CR+, CHA/V, NUMBERED keys,
INPUT, SEARCH or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
Cable Box Setup
Process of Recording
Connection
o ©saffljj)
Programming
1
Display menu.
Press ACTION.*
MENU
SET UP VCR
SET UP FEATURE
SET CLOCK
ISET UP CHANNELI
ID lOMA/ UNGUE: ENGL! SH
VCR' S OUTPUT CH:3
SELECT:*
T
KEY
SET :► KEY
END :ACT I ON KEY
Select SET UP CHANNEL.
1) Press
AT
to
select.
2) Press ► to
display.
3
SET UP CHANNEL
ANTENNA : CABLE
AUTO SET
WEAK SIGNAL DISPLAY : OFF
ICABLE/DSS BOX SET UP|
VCR Plus+ CH SET UP
SELECT:* ▼ KEY
SET :► KEY
END :ACT I ON KEY
Select CABLE/DSS BOX
SET UP.
1) Press
AT
to
select.
2) Press ► to
display.
SELECT HOOKUP
[CABLE/DSS BOX^VCR»TVl
VCR^CABLE/DSS BOX^TV
VCR^TV
SELECT:* ▼ KEY
SET :► KEY
END :ACT I ON KEY
Select your hookup
method.
1) Press
AT
to
select.
2) Press ► to set.
• If CABLE/DSS BOX ►VCR ►TV,
go to step 5.
If other, press ACTION three
times and go to page 16.
SELECT HOOKUP
CABLE/DSS BOX^VCR^TV
CABLE/DSS BOX OUTPUT CH
BaEB
SELECT:* ▼ KEY
SET :■* > KEY
END : ACT I ON KEY
Select cable box or DSS
receiver output channel.
1) Press
AT
to
select,
2) Press ► to
enter.
• If necessary, refer to your Cable
Box/DSS manual.
here.
• If you are using Audio/Video jack
connections, select and set
"VIDEO OUT' as output channel.
End setup.
Press ACTION twice.
VCR Plus+ and PlusCode
are registered trademarks of
Gemstar Development
Corporation. The VCR Plus+
system is manufactured
under license from Gemstar
Development Corporation.
V__
y
15