Table of Contents
Advertisement
pplying power .
Be Ea
a
RS OP ea EF Ea
Tee EEE ae
Ee
alla eee ae
¢ Units are designed for operation as follows.
U.S.A, Mexico ad Ca ada ssesecseccceeeecerscissssnnisenmnes 120 V only
OOF COUNITIOS esssssessssccrseesseessseecsrsrserseeseiee 110~120 { 220~240 V swite
PUSHED sssiseicvccosincrinmivertocnssindnieeisotssrssntiseriosstrmestitronstsommsscsstennnised tO V ONLY
AC voltage selection
AC voltage Selector switch
This unit operates on 110 - 120 volts or 220 -
240 voits AC, The AC voitage selector switch
AAG tt0-
:
Ae Taviaois: "AC palo E
3
<_h
on the rear panel is set to the voltage that pre-
vails in the area to which the unit is shipped.
Before connecting the power cord to your AC
outlet, make sure that the setting position of
this switch matches your line voltage. If not, it
must be set to your voltage in accordance with
the following direction.
:
|
KR-V7060
|
KR-V6060
Note:
ee
Move switch lever to match your line voltage with
Our warranty does not cover damage caused by excessive line
a small screwdriver or other pointed tool.
voltage due to improper setting of the AC voltage selector switch.
._,oafety precautions _..
WARNING :TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
RISK OF ELECTAIC SHOCK
(OR BACK), NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED
THE LIGHTNING
FLASH WITH ARROWHEAD
SYMBOL, WITHIN AN EQUILATERAL TRIANGLE,
IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED
"DANGEROUS VOLTAGE"
WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A
RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE,
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an
unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to camply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rutes. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by ane or more of the following
measures;
~~ Reorient or relocate the receiving antenna.
~- Increase the separation between the equipment and receiver.
—- Connect the equipment into an outlet_on a circuit different from that to which the receiver is connected.
~— Consult the dealer or an experienced radio / TV technician for help.
For the U.S.A.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of
cable entry as practical.
Advertisement
Table of Contents
