Table of Contents
Advertisement
aoe : Remote control unit
=
Remote control operation is not possible.
e Replace with new batteries. + P32]
® Operate the remote control unit within the
controllable range.
e Batteries are exhausted.
® The remote control unit is too far away from
the main system, controlling angle is tco
large, or there is an obstacle in between.
@ The audio cords and system control cords are
not connected properly.
@ The source component to be operated does
not contain the tape(s) or CD.
@ An attempt is mace to play a tape which is
being recorded in the cassette deck.
e Connect
properly
referring
to "System
connection".
+[P.4] +28)
7
@ Place the tape(s) or CD in the source com-
ponent to be played.
e Wait unit! the recording is completed.
Amplifier
at
aN
E E LESTE
RTT
ra
a eae
Saha an
Pecan TEEN
EE
tu.
'
e Adjust the volume to a proper level. +
e@ The VOLUME
is set to the minimum posi-
tion.
@ The MUTE key is set to ON and the point
indicator is blinking.
@ The SPEAKERS switches are set to OFF.
e The TAPE 2 key is set to ON.
e@ Press the MUTE key to OFF.
e Set the SPEAKERS switch(es) to ON.
@ Set the TAPE 2 key to OFF,
The STAND BY indicator blinks and sound
is not output.
@ Turn the power off, eliminate the short-cir-
cuiting, then turn on the power again.
@ Speaker cords are short-circuited.
e Connect it properly referring to "System
connection".
e Adjust the Left/Right balance.
Soundis not output from one of the speak-
ers.
@ The speaker cord is disconnected.
e The BALANCE contro! is set to an extreme
position.
@ Connect them properly referring to "Sys:
tem connection".
e Set the presence mode.
~
evhe
rear-speaker
cords
and/or
center
speaker cord are disconnected.
e@ The Surround play mode has not been en-
gaged.
e The REAR VOL. and/or CENTER VOL. con-
trols are set to the minimum level.
Sound is not output from the Surround
rear speaker and/or center speaker,
or
their sound is very small.
e Adjust the REAR VOL, and CENTER VOL
controls.
e Insert the audio cord plugs securely inis
the PHONO jacks.
e Connect the grounding wire to the GNI
terminal on the rear panel.
A hum
noise
is generated
when
the
PHONO input selector key is pressed.
@ The audio cord from the turntable is not in-_
serted securely into the PHONO jacks.
@ The turntable is not grounded.
period of time.
;
they may deform the plastic components.
Advertisement
Table of Contents
