Fcc Warning - Kenwood KR-V5570 Instruction Manual

Hide thumbs Also See for KR-V5570:
Table of Contents

Advertisement

this page Caretulty to ensure safe operation
KR-V5570 [En]
Units are designed for operation as follows.
USA. ANd CANA vresresscernssersssestnaersennrerrssimessnneee AG 120 V only
UK, Ad EUrOpar ..ecoesscceensereeerseensiinenssrssiescereerne AG 230 V only
AUSTIANG ..cocerecsernteesriscuanineeieemenesersuminnseinenemenenn AG 240 ¥ only
*OthEr COUNTIES ...crceceseeerssreeseessereen AG 110-120 / 220-240 V switchable
*AC voltage selection
AC voltage selector switch
The AC voltage selector switch on the rear panel is set to the
AC 110-
AC 220-
voltage that prevails in the area to which the unit is shipped. Be-
120V~
~a hm 240V~
fore connecting the power cord to your AC outlet, make sure that
the setting position of this switch matches your line voltage. If
not, it must be set to your valtage in accordance with the fotlow-
ing direction.
Note:
Our warranty does not cover damage caused by excessive line
iene
LEN Nets ots
aETG
eat teen ened t ePaaeT TEREST OT
NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION
|
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
/
RISK OF ELECTRIC SHOCK
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED
DOHOT PEN
SERVICE PERSONNEL.
THE LIGHTNING
FLASH WITH ARROWHEAD
SYMBOL,
WITHIN AN EQUILATERAL TRIANGLE,
|S
INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED
"DANGEROUS VOLTAGE"
WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A
RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO,
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.
For the U.S.A.
FCC WARNING
NOTE:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio / TV technician for heip.
For the U.S.A.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper
grounding and, in particular, specifies that the cable ground shail be connected to the grounding system of the building, as close to the point of
cable entry as practical.

Advertisement

Table of Contents
loading

Table of Contents