Effect Output Level, Stereo Mix - Yamaha V50 Operating Manual

a,
ey
6: Stereo Echo
Echo spread left/right
7; Distortion Rev.
Combination of distortion and reverb
8: Distortion Echo
Combination of distortion and echo
9; Gate Reverb
Reverberation with "artificially" fast cutoff
10: Reverse Gate
Reverberation simulating backwards tape playback
11: Early Ref
Adds early acoustic reflections to the sound
12: Tone Control t
Three band equalizer
13: Delay & Reverb
Combination of delay and reverb
14: DelayL/R & Rev.
Combination of delay L/R and reverb
15: Dist. & Delay
Combination of distortion and delay
16: Church
Reverberation simulating a church
17; Club
Reverberation simulating a music club
18: Stage
Reverberation simulating a larger live music club
19; Bath Room
Reverberation simulating a bathroom
20: Metal
Metallic reverberation
21: Tunnel
Reverberation simulating a tunnel
22: Doubler 1
Doubling effect
23: Doubler 2
Doubling effect (spread left and right)
24: Feed Back Gate
Gate reverb with feedback
25: Baek Reverse
Reverse gate with feedback
26: Feed-Back E/R
Early reflections with feedback
27: Delay & Tonel
Combination of delay and tone control |
28: Dly L/R & Tonel
Combination of delay L/R and tone control 1
29: Tone Control 2
Tone control using low pass filter and high pass filter
30: Delay & Tone2
Combination of delay and tone control 2
31: Dly L/R & Tone2
Combination of delay L/R and tone control 2
32: Distortion
Distortion effect
Note:
Settings for "Balance", "Out Level" and "Stereo Mix"
will vary for each effect.
(2) Effect balance
E Function
Set the volume balance of the unprocessed sound and
the effect.
E Settings
0% — 100%
Æ Explanation
As you increase the setting, the effect sound will be-
come louder. As you decrease the setting, the un-
processed sound will become louder.
Notes: 2s eee
At a setting of 0% the effect will not be heard, and
you will hear only the unprocessed sound. Ata setting
of 100% the unprocessed sound will not be heard,
and you will hear only the sound of the effect.
Since the number keys enter two-digit numbers,
it is not possible to directly enter a value of 100. If
you need to enter a value of 100, use the data entry
slider or ~ 1/+1 keys after entering 99.
Effect output level, stereo mix
Press [EFFECT] three times. (If effect select is turned
off, you will not be able to select this function.)
| PED EFCT? FOutLewe | = Sthoepenn
| à or
N
(1) — L—. (2) !
(1) Effect output level
@ Function
Set the output volume of the effect.
Performance Edit 31