Table of Contents
Advertisement
10
Heat the 2 microwaveable heating bags for 40-60 seconds in a 700 W microwave
and apply each one at the front and back of the bottom right edge of the device for
1 minute.
11
While maintaining the heating bag under the back of device, place the suction cup (L)
in the bottom of the right edge of the screen, lift upwards carefully, and then insert
the opening pick in the gap.
Be careful when inserting the opening pick too deeply as this could damage the
internal circuitry, leading to problems such as abnormal operation of the screen.
In case of the bottom edge side of the screen, very weak circuits are located
•
very close to the edge. Just insert only about 1 mm.
As the screen can be damaged by excessive force, be careful not to damage the
•
screen.
Be careful that the suction cup does not adhere to the area where the tape or
•
sticker is attached.
If you have trouble creating a gap, heat the microwaveable heating bag
additionally, and apply it on the screen to further soften the adhesive. When
reheating, it should be heated no longer than 40-60 seconds.
Disassembly and Assembly
71
Advertisement
Table of Contents
