Roland M-16E Owner's Manual page 16

3
CONNECTION AND OPERATION
initial Procedure
TyMake sure that the unit is switched off, then
connect the power cord to the socket.
2Connect all the relevant devices.(See the picture
shown below.)
3:Set all the control knobs and faders to zero.
PSet the Phantom Switches of the channel where
condenser microphones are to be connected tc the
ON positions. Be sure that all the other Phantom
Switches are set to the OFF positions.
@Make sure that connections are correctly made.
switch on the input devices first. the mixer, then
finally the power amplifier.(/When switching off
the units, take the reversed order.)
1. Setup with a Microphone, Electronic Musical Instrument, etc.
QS
i Kayboard Electric Guiter etc.
(ee aa G-707(GR-700
S-506te G77 (GA-77B ate
| Micraphane
[OR-45. OA-35
Congenser Microphone ate
]
yin
ty
ouT
Power Amplifier
'SRA- 1200
SRA-2400 H
SRA -4806 ate Speaker
MEMixing with a Microphone, Electronic
Musical Instrument, etc.
DAs you actually listen to the sound, adjust the Sens
Contrel Knob so that the Peak/Signal indicator
occasionally lights in red.
@Set the Channel Faders around 7. then adjust the
overall volume with the Master Faders.
'Control the tone of sound at the Equalizer section.
4
4-800. 1500
SRS-8C 126 ete
*If the Peak/Signal Indicator lights
frequently, lower the Sens Contro! Knob.
in red too
'PSet the sound positioning of the L and R with the
Panpot.
Adjust the volume balance of each channel with the
Channel Fader.