Roland M-16E Owner's Manual page 13

@Master Faders
These adjust the final output level of the mixed
signa].
+*in the Master Faders, "8° is the rated output.
@Effect Send Volume Controls
These adjust the level of the signal sent to the effect
units.
*In the Effect Send Volume Controls, "7° is the rated
output.
@AUX Send Volume Control
This adjusts the final output level of the signal which
has been level~adjusted in the AUX Volume in each
channel.
*In the AUX Send Volume Control, "7" is the rated
output,
@ Monitor Send Volume Control
This adjusts the final output level of the signal which
has been level~adjusted at the Monitor Volume of
each channel.
*\|n the Monitor Send Volume Control, "7" is the rated
output.
@AUX Select Switch
This selects the position where the signal is sent to
the AUX Send. When it is set to "PRE", the signal is
sent before the Channel Fader, and therefore can be
used for monitoring. When it is set to "POST", the
signal is sent after the Channel Fader. and therefore
can be used for effect send.
@eEffect Send Cue Switch
This sends the effect signal to the Headphones or Cue
Out.
*The signal is sent to the Headphones or Cue Out
before the Effect Send Volume.
@®AUX Send Cue Switch
This switch sends AUX signa! tc the Headphones or
Cue Out.
*The signal is sent to the Headphones or Cue Out
before the AUX Send Volume.
@®Monitor Send Cue Switch
This switch sends monitor signal to the Headphones
or Cue Out.
* The signal is sent to the Headphones or Cue Out
before the Monitor Send Volume.
®Cue Indicator
This lights in red when more than one Cue Switch is
pressed down.
@Headphones/Cue Volume Controi
This controls the volume of the Headphones or Cue
Out.
@Headphones Socket
Provides connection for stereo headphones.
Normally, the signal from each Channel Fader is
mixed and output, but when the Cue Switch is pressed
down, only the cue signal is output.
@®Power Indicator
This lights up when the unit is switched on.
®Power Switch
Pressing this switch down will switch on the unit.
Pressing the switch again will switch the unit off.
* Before switching on or off the unit, be sure to set the
Master Faders to zero.
%* For about three seconds after the unit is switched on,
the muting circuits function, therefore no sound is
output.