Table of Contents
Advertisement
@insert Sockets
These are inpui and output sockets for connec'
effect
vw each
channel.
These
can
alse
be used
for
direct output from channels
%*The
signal
is output
after
the
Equalizer
and
before
the Channel On Switch.
%* Use
Insert Cable
(PCS-31)
for connecting
an effect
unit and @ standard
phone cable for using as @ direct
output,
SEND
RETURN
GND
RETURN(RED)
SEND(BLACK)
Freer en
@Return Sockets
@Rec Out Sockets
These
are
output
sockets
for
connecting
a
tape
recorder,
etc. The Rec Out Sockets
cannot
perform
monitor playback and recording at the same time.
%* When
recording
onto
a
tape
recorder,
oscillation
may
occur
when
the
playback
sound
on
the
tape
recorder
is returned
to
the
mixer.
Set
the
Input
Volume Control where the tape recorder is connected
to zero or disconnect it.
*The
signa!
is output
before
the Master
Fader(pre
fader).
@Master Out Sockets
These
are
output
sockets
for
connecting
4 power
amplifier, etc.
GETTECT
SeNc
SOCKETS
These are for sending signa! to an effect unit
@AUX Send Socket
This sends signa! to an effect unit or monitor.
@Monitor Send Socket
This sends signal to a monitor.
@Cue Send Sockets
Cue signal is sent through these sockets.
%* When the Cue Switch is not used, the signal from the
Master Out(pre fader) is output.
@Bus In Sockets
These can be directly connected to the Effect Send.
AUX
Send,
Monitor
Send
and
Master(L
and
R)
busses for mixing. When stacking two mixers, you
can extend the input channels by feeding signals to
the Bus In Socket on the master mixer from the Send
or Master Out on a slave mixer.
@®Master Out Connectors
These are XLR(balance)
type output connectors for
connecting a power amplifier, etc.
* There
are two
types
of XLR
connectors'
pin stand-
ards; USA and Europe types.
This
unit
adopts
USA
type(1st:GND,
2nd:COLD,
Q@rd:HOT).
When
connecting
this
unit
with
other
devices,
make
sure the pin standard of the devices
match this unit's.
@
D ®
@)
3
3
+:GND
2:COLD
3:HOT
Advertisement
Table of Contents
