Panasonic EYFLA7AR Quick Programming Manual page 7

Editing the Parameters for each tool
Tools can only be learned to Parameters 1-16.
•
Parameters 17-100 are assignable to any of the tools 1-16.
•
1. Go to "Parameters", from the main menu.
2. Select the parameter location you want then press "edit"
(Assembly Manager software is available on our
to make parameter changes, create jobs, groups, etc.)
Parameters/Features
1. Name the Parameter
2. Socket Tray
3. Set the Batch count
4. Select lock on batch if required
5. Torque Settings: 1-40. Default – 1
6. Flush Detection: 1-7. Default – 1
7. Buzzer settings: Off, OK, NOK. Default - Off
8. Flush Detect Delay: .1 – 3 sec. Default – 0
9. LED light: Trigger switch or LED button. Default – LED Button
10. Cross thread/Rehit: 0-3 sec. Default – 0
11. Variable speed: Variable Speed or Single. Default – Variable
12. Cross Thread reduction: 540˚ reverse or OFF. Default – OFF
13. Retightening Prevention: 0-3sec. Default - 0
14. Socket ext. mode: 150mm. 250mm, None. Default - None
*Two-Way communication mode – The Qualifier will change tool features and will override any settings made by the remote control.
Two-Way Quick Programming Guide
Website and can also be used