Panasonic EYFLA7AR Quick Programming Manual page 4

Note: The Default setting for the models listed on page 1 is One-Way communication mode.
Important: The communication mode must be changed with the remote
the qualifier to initiate Two-Way communication. (See below instructions)
To change the tool communication mode from the default "90" (one way) to "91" (two-way)
1. Put the tool into program mode
2. Press "C" button on the remote 4 times
3. Press the + button on the remote to select "91" (two-way)
4. Press the Blue set button to save the changes
Sleep Mode
• If the tool is in "sleep mode" (timed out from no operation and no display) Default is 20 min. the tool will not communicate
Tool sleep time can be changed in the qualifier settings under Qualifier setting page 2 (select next) then select "Tool on time". Sleep
•
time range is 20 -720 min.
Pulling the tool trigger will "wake" the tool and initiate communication.
•
In the event the qualifier is powered down or loses power while the tool is in sleep mode, you must power up the
qualifier first before waking the tool from sleep to initiate two-way communication. Otherwise you will need to pull
and reinstall the battery on the tool
Two-Way Quick Programming Guide
before learning the tool to