Bosch KFN96 Series Installation Instructions And Instructions For Use page 9

Lift the drawer and remove the lower screw on both
4.
sides.
Move the drawer upwards or downwards into the
5.
required position and screw the lower screw into one
of the available holes.
The drawer can be adjusted by 1/16" (2 mm)
Note:
up and down.
Retighten all screws.
6.
To check the position, close the drawer and correct
7.
if necessary.
You can adjust the angle of the drawer:
Open the drawer as far as it will go and remove the
1.
container.
Remove the middle screw on both sides.
2.
Installation and connection
If you want to reset to the drawer to the factory
Note:
settings, retain the screws.
Loosen the upper and lower screw on both sides.
3.
Do not remove the screws.
Note:
Move the drawer left or right into the desired position
4.
on the lower screw and tighten the screw.
Retighten all screws.
5.
To check the position, close the drawer and correct
6.
if necessary.
en
9