Bosch KFN96 Series Installation Instructions And Instructions For Use page 8

Installation and connection
en
Align the horizontal gap between the doors:
Caution!
To avoid damage to the appliance, move the right-hand
door down if the door pillar at the top collides with the
housing.
Remove the contents of the doors, if present.
Note:
Open the door and drawer.
1.
Lift the door and insert a screwdriver into the door
2.
hinge from below.
Push up the adjustable part and turn through 60°
3.
until the desired position is reached.
– The door height can be set at 2 levels, adjusted
by 1/16" (1.5 mm) in each case. The higher level
is followed by the lower. The adjustable part
engages as soon as a position is reached.
– To move the door up, turn clockwise.
– To move the door down, turn anticlockwise.
8
To check the position, close the door and drawer
4.
and correct if necessary.
Aligning the drawers
You can align the drawer vertically:
Open the drawer as far as it will go and remove the
1.
container.
Remove the middle screw on both sides.
2.
If you want to reset to the drawer to the factory
Note:
settings, retain the screws.
Loosen the upper screw on both sides.
3.
Do not remove the screws.
Note: