Hoshizaki KMD-201AWA Service Manual page 56

7) While pulling up the bin control lead, hook the bin control on the right side interior wall.
Then push the bin control up against the bottom of the unit, and slide to the back until it
snaps in place. Make sure the slotted holes at the right side of the bin control are securely
placed on the collars at the bottom of the unit.
Make sure the bin control is securely in place. Otherwise, ice may get between
gaps and damage the bin control.
8) Pull up any slack in the bin control lead, then put the bushing attached to the bin control
lead back into the hole in the base.
9) Connect the bin control connector to the side of the control box.
10) Replace the water tank, cube guide, pump motor bracket, pump motor and float switch
in their correct positions until they snap in place.
Be sure to let the discharge hose pass behind the copper tube and connect it
securely in position. Otherwise, the discharge hose may be caught in the front
insulation, leading to improper results.
11) Secure the pump motor bracket with the two thumbscrews.
12) Reconnect the pump motor connector and float switch connector.
13) Replace the front insulation and front panel in their correct positions.
14) Turn on the power supply.
CAUTION
CAUTION
53