Suunto Spartan Sport Wrist HR Baro
NOTE: Sport modes have their own alti-baro profile setting. You can change this setting
in Movescount. The options are automatic, barometer only, or altimeter only.
3.25. Pairing PODs and sensors
Pair your watch with Bluetooth Smart PODs and sensors to collect additional information, such
as cycling power, when recording an exercise.
Suunto Spartan Sport Wrist HR Baro supports the following types of PODs and sensors:
•
Heart rate
Bike
•
Power
•
Foot
•
NOTE: You cannot pair anything if airplane mode is on. Turn off airplane mode before
pairing. See 3.2. Airplane mode.
To pair a POD or sensor:
1. Go to your watch settings and select Connectivity.
2. Select Pair sensor to get the list of sensor types.
3. Swipe down to see the whole list and tap on the sensor type you want to pair.
4. Follow the instructions in the watch to complete pairing (refer to sensor or POD manual if
needed), pressing the middle button to advance to the next step.
If the POD has required settings, such as crank length for a power POD, you are prompted to
enter a value during the pairing process.
Once the POD or sensor is paired, your watch searches for it as soon as you select a sport
mode that uses that sensor type.
You can see the full list of paired devices in your watch from the settings under Connectivity »
Paired devices.
From this list, you can remove (unpair) the device if needed. Select the device you want to
remove, and tap Forget.
3.25.1. Calibrating bike POD
For bike PODs, you need to set the wheel circumference in your watch. The circumference
shall be in millimeters and it is done as a step in the calibration. If you change the wheels (with
new circumference) of your bike, the wheel circumference setting in the watch must also be
changed.
33