Table of Contents
Advertisement
IMPORTANT:
Check and comply with all state and local codes that may apply to vented heaters before
beginning installation.
NOTE: This heater is designed to be used no more than 3000 FT. above sea level.
ASK your local dealer for using at altitudes higher than 3000 FT. above sea level.
1.
Select heater location. Allow clearances as indicated below between heater and all other materials.
(See Fig. 1)
2.
Make sure that the outside area to where the flue pipe will reach is clear of any objects.
(See Fig. 2 & 3)
CAUTION: If the flue pipe is installed in the wall more than 9 in. thickness, exhaust pipe can be
disconnected. Never install the flue pipe in the wall more than 9 in. thickness.
NOTE: Flue pipe can be installed through any standard building materials. Please ask your local dealer
or distributor for more details.
NOTE: The wall thickness which the flue pipe can be installed is from 4 in. to 9 in. If it is more than 9
inches, consult your local dealer.
Combustible object
Not less than 6 in.
Fig. 2
INSTALLATION OF HEATER AND FLUE PIPE
More than 6 in.
(4 in.)*
More than 5 ft.
Combustible object
Noncombustible object
45˚
Not less than 1 ft.
Flue pipe
* Not less than 8 in.
More than 6 in.
More than 4 in.
More than 6 in.
(4 in.)*
( )
Non combustible materials.
*
More than 12 in. for maintenance
or inspection.
Fig. 1
Not less than 2 ft.
* Be sure this
clearance will
be maintained
after snowfalls,
etc.
Not less than 1.5 ft.
Not less than
1.5 ft.
Fig. 3
23
Hide quick links:
Advertisement
Table of Contents
