Safety Tips For Installation - Toyostove Laser 30 Type B Installation And Operation Instructions Manual

Follow the safety tips below when planning the installation of your Laser 30.
1. Intake and exhaust flue pipe openings must be fully exposed to outside air.
Do not vent into garage, basement under the floor, or into any enclosed
area.
2. Do not install flue pipe in close proximity to other objects or materials (See
page 22).
3. Before making a hole in your wall for the flue pipe, make sure the area is free
of electrical wires, gas pipes and other obstacles.
4. Do not install flue pipe where it will be exposed to heavy snow collected
leaves or strong drafts.
Important:
In areas of hea-
vy snow falls,
ground surface
clearance must
be increased
according to
average snow
falls.
5. Do not install the flue
pipe down from the
heater nor into chim-
ney.
6. Total length of extension pipe between heater and flue pipe must be no
greater than 10 ft. and 3 bends may be used.
NOTE: When using extension pipes always cover the exhaust pipe with the
insulating cloth cover.
21

SAFETY TIPS FOR INSTALLATION

Important:
In open area
with strong
wind, a wind
break may be
necessary.