Table of Contents
Advertisement
Figure 18
1. Tap bolt
2. Lock bracket
2.
On the ProCore 1298 model, install a lock
bracket over all the rear lower hood latches and
the outside upper hood latch on both the right
and the left rear covers with a tap bolt (3 per
coring head, 6 total); refer to
3.
Using a pliers or adjustable wrench, thread
an internal lock washer onto each bolt (1 to 2
threads) to secure the latch
11
Removing the Storage
Stands
Parts needed for this procedure:
4
Lynch pin (ProCore 864)
8
Lynch pin (ProCore 1298)
Procedure
1.
Raise the aerator 7.6 to 15.2 cm (3 to 6 inches)
off the ground.
2.
Remove the nuts and the lock washers securing
the storage stands to the aerator
g007299
3. Internal lock washer
4. Rear cover
Figure
18).
(Figure
18).
(Figure
19).
1. Storage stand
2. Lock washer
3.
Remove the storage stands.
4.
Insert the lynch pins (included in loose parts)
into the stand pins for storage
5.
Use the storage stands whenever the aerator is
removed from the tractor.
15
Figure 19
3. Nut
(Figure
19).
g007303
Advertisement
Table of Contents
