Philips Wet&Dry S7000 Series User Manual page 26

28
English
2
1
5 To let the shaver dry, you can leave it in the
SmartClean system until your next shave. You
can also remove the shaver from the
SmartClean system, shake off excess fluid, open
the shaving unit and let the shaver air-dry.
Press to open the SmartClean cap, to remove
the shaver from the holder ('click').
Note: Note: If you press the on/off button of the
SmartClean system during the cleaning program,
the program stops. In this case, the cleaning or
drying symbol goes out.
Note: Note: If you disconnect the SmartClean
system from its power supply, the cleaning
program stops.
Replacing the SmartClean cartridge
Replace the cleaning cartridge when the
replacement symbol flashes orange or when you
are no longer satisfied with the cleaning result. If
you clean the shaver with the SmartClean system
once a week, the cartridge lasts approximately
three months.
1 While holding the SmartClean system with one
hand, press the button on the side and lift the
top part of the SmartClean system.
2 Remove the cleaning cartridge from the
SmartClean system and pour out any remaining
cleaning fluid. You can safely pour the cleaning
fluid down the sink.
3 Discard the empty cleaning cartridge.
4 Unpack the new cleaning cartridge and pull off
the seal.