NETGEAR RAX40 User Manual page 161

4-stream ax3000 wifi router
Hide thumbs Also See for RAX40:
Table of Contents

Advertisement

3. If you do not receive replies, check the following:
• Check to see that IP address of your router is listed as the default gateway for
your computer. If DHCP assigns the IP configuration of your computers, this
information is not visible in your computer Network Control Panel. Verify that the
IP address of the router is listed as the default gateway.
• Check to see that the network address of your computer (the portion of the IP
address specified by the subnet mask) is different from the network address of
the remote device.
• Check to see that your cable or DSL modem is connected and functioning.
• If your ISP assigned a host name to your computer, enter that host name as the
account name on the Internet Setup page.
• Your ISP might be rejecting the Ethernet MAC addresses of all but one of your
computers.
Many broadband ISPs restrict access by allowing traffic only from the MAC address
of your broadband modem. Some ISPs additionally restrict access to the MAC address
of a single computer connected to that modem. If your ISP does this, configure your
router to "clone" or "spoof" the MAC address from the authorized computer.
Troubleshooting
Nighthawk AX4 4-Stream AX3000 WiFi Router
161
User Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nighthawk ax4

Table of Contents