NETGEAR RAX40 User Manual page 10

Table 1. LED descriptions
LED and Button
Power LED
Internet LED
Ethernet LEDs for ports 1–4
USB 3.0 port LED
WiFi LED
WPS LED
Note: If the LED On/Off switch on the rear panel is moved to the Off position, all the
LEDs except the Power LED are turned off.
Hardware Setup
Nighthawk AX4 4-Stream AX3000 WiFi Router
Description
Solid green. The router is ready.
Blinking green. The router is not ready, firmware is upgrading, or the Reset
button was pressed.
Off. Power is not supplied to the router.
Solid green. The Internet connection is ready.
Blinking green. The port is sending or receiving traffic.
Off. No Ethernet cable is connected between the router and the modem.
The LED color indicates the speed: green for Gigabit Ethernet connections and
amber for 100 Mbps or 10 Mbps Ethernet connections.
Solid green. The router detected a 1 Gbps link with a powered-on device.
Blinking green. The port is sending or receiving traffic at 1 Gbps.
Solid amber. The router detected a 100 Mbps or 10 Mbps link with a powered-on
device.
Blinking amber. The port is sending or receiving traffic at 100 Mbps or 10 Mbps.
Off. No device is connected to this Ethernet port.
Solid green. A USB device is connected and is ready.
Blinking green. A USB device is plugged in and is trying to connect.
Off. No USB device is connected, or someone clicked the Safely Remove
Hardware button and it is now safe to remove the attached USB device.
Pressing the WiFi button for two seconds turns WiFi LED and WiFi radios on and
off.
If this LED is lit, the WiFi radios are on. If this LED is off, the WiFi radios are turned
off and you cannot use WiFi to connect to the router.
Pressing the WPS button lets your WPS-enabled device join your router's WiFi
network without typing the WiFi password. The WPS LED blinks green during
the WPS process and then lights solid green when the WPS-enabled device
connects to your router's WiFi network.
10 User Manual