Rear Panel - NETGEAR RAX40 User Manual

Rear panel

The following figure shows the rear panel connectors and buttons.
Figure 3. Rear panel
Viewed from left to right, the rear panel contains the following components:
• Power On/Off button. Press the Power On/Off button to provide power to the
router.
• DC power connector. Connect the power adapter that came in the product package
to the DC power connector.
• Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the router to an
Internet modem such as a cable modem or DSL modem.
• Ethernet ports. Four Gigabit Ethernet RJ-45 LAN ports. Use these ports to connect
the router to LAN devices.
• Reset button. Pressing the Reset button resets the router.
If the Reset button is pressed for at least 10 seconds and the Power LED blinks green,
the router returns to its factory settings. For information about the factory settings,
see Factory Settings on page 163.
• LED On/Off switch. Move the LED On/Off switch to the Off position to turn off the
router LEDs. The Power LED stays lit even if the LED On/Off switch is in the Off
position.
Hardware Setup
Nighthawk AX4 4-Stream AX3000 WiFi Router
11 User Manual