(3. 2) Pulse Width Trigger Sync-Non Reset; Picture Output Timing (At Time Of Internal Sync) - Toshiba IK-TF5C Instruction Manual

(3. 2) Pulse Width Trigger SYNC-NON RESET Picture Output Timing (at Time of Internal Sync)
Trigger* 1
Exposure period*
(Internal VD)* 3
RGB data
(video interval image)
FVAL
LVAL,
DVAL
*1: Externally input signal
*2: Exposure time = Trigger pulse width + 6 µs
(Valid trigger pulse width is 2 µs or greater for external trigger shutter operation.)
*3: As long as there is no external sync input, the internal VD will be output when SJ01 is set to HD/VD output
position.
*4: Video is output at the falling edge of the internal VD following completion of the exposure period.
The video and FVAL/LVAL/DVAL have a paired relationship.
Note:
When the next trigger is input before completion of the output of the video corresponding to the trig-
ger, there will be an effect on the video.
28
About 7 µs
About 1 µs
2
20H (Partial scanning OFF)
18H (Partial scanning 120fps)
23H (Partial scanning 180fps)
Negative polarity mode
Positive polarity mode
Exposure period* 2