Sony HCD-G2BNiP Service Manual page 4

HCD-G2BNiP/G2NiP
NOTE OF REPLACING THE WIRELESS LAN MODULE
(MOD1)
When replacing the wireless LAN module (MOD1), MAC address
is changed. Print the following explanation, cut it, and hand over
it to the customer with the unit, when returning the unit that the
repair is completed to the customer.
MAC address of the main unit has been changed by this repair.
When using the MAC address fi ltering function of connection destina-
tion access point equipment, set it again..
CHECKING METHOD OF NETWORK OPERATION
It is necessary to check the network operation, when replacing the
wireless LAN module (MOD1). Check the operation of wireless
and wired LAN, according to the following method.
1. Checking Method of Wireless LAN Operation
Check that access point is recognized surely.
Necessary Equipment:
Wireless access point with router function (AP)
Procedure:
1. Turn the [FUNCTION] knob to select the HOME NETWORK,
MUSIC SERVICES or AirPlay function.
2. Press the [M]/[m] buttons to select "Network," then press the
[ENTER] button.
3. Press the [M]/[m] buttons to select "Settings," then press the
[ENTER] button.
4. Press the [M]/[m] buttons to select "Wireless LAN Settings,"
then press the [ENTER] button.
Note: If "Change Setting?" appears, select "OK," then press the [ENTER]
button.
5. Press the [M]/[m] buttons to select "Access Point Scan," then
press the [ENTER] button.
6. The system starts searching for access points, and displays a
list of up to 20 available network name (SSID).
7. Check that access point (SSID) is displayed on the searching
result.
Note: Refer to the instruction manual about details of the setting method.
2. Checking method of wired LAN operation
Check that access point is recognized surely.
Procedure:
1. Connect the main unit to the router or the hub, etc. with the
network (LAN) cable.
2. Turn the [FUNCTION] knob to select the HOME NETWORK,
MUSIC SERVICES or AirPlay function.
3. Press the [M]/[m] buttons to select "Network," then press the
[ENTER] button.
4. Press the [M]/[m] buttons to select "Settings," then press the
[ENTER] button.
5. Press the [M]/[m] buttons to select "Wired LAN Settings,"
then press the [ENTER] button.
6. On the IP setting, press the [M]/[m] buttons to select "Auto,"
then press the [ENTER] button.
7. On the proxy setting, press the [M]/[m] buttons to select "Do
Not Use," then press the [ENTER] button.
8. Press the [M]/[m] buttons to select "OK," then press the
[ENTER] button.
9. Perform the server settings.
10. Press the [OPTIONS] buttons to select "Network," then press
the [ENTER] button.
11. Press the [OPTIONS] buttons to select "Information," then
press the [ENTER] button.
12. Check that IP address can be acquired.
Note: Refer to the instruction manual about details of the setting method.
4