Panel (Rear) Block - Sony HCD-G2BNiP Service Manual

HCD-G2BNiP/G2NiP
2-6.

PANEL (REAR) BLOCK

Note 1: Refer to "WIRE SETTING" on page 9 for wire setting.
2 coating clip
(G2BNiP)
qa flexible flat cable (8 core) (CN408)
7 connector
(CN701)
CN406
4 Lift up the lead pin.
8 connector
(CN4404)
9 connector
(CN4405)
– Rear side view –
Clamp tilter (ferrite core) setting
clamp tilter (ferrite core)
coating clip
AC inlet
rear side
qh panel (rear) block
qs three screws
(BV/ring)
14
1 two screws
(BVTP2.6)
3 holder (BREDGECO)
6 connector
(CN5004)
5 2.4 GHz antenna
connector
Note 3: There are two terminals for antenna wire in a module.
55 mm
qd
– Rear side view –
qs two screws
(BV/ring)
Note 2: When you install the flexible flat cable, please install them
correctly. There is a possibility that this machine damages
when not correctly installing it.
OK
Insert is straight to the interior
flexible flat
cable
connector
0 flexible flat cable (9 core) (CN407)
Note 4: Both the flexible flat cable (9 core) can be connected with
the CN406 or CN407 on MAIN board.
When you connect the flexible flat cable (9 core) with the
CN407 on MAIN board so as not to connect it by mistake.
When connecting the antenna wire, connect with the
right terminal.
wireless LAN module
(MOD1)
OK
NG
qg coating clip
qf screw
(BV3)
NG
Insert is incline
flexible flat
cable
connector