Roland HP 1300e Owner's Manual page 4

Assembling the KS-1300e Stand for the HP-1300e/HP-1600e eee
Thank you for purchasing the Roland KS-1300e/1600e piano stand.
To ensure long and trouble-free use, please read this instruction sheet carefully before assembly.
@ Check the varts
Before you begin sssembly, ci
Side board jlatt) »
Side board (right)
Pedal doard-
Center board
tong screws (M6 x 54 mm) -
Shon screws (M4 x 2? mm) «
Knob boits---
Plus scrawdriver:
Cable clamps->
@E@OO GOO
@Assembly procedure
that you have sli the parts,
L
aes
a
S
|7 J Attach the side boards (left and right) to the pedal board.
wy Extand the pedal cable out from the pedal board.
(Now) Be sure thas the side boards are oriented
correctly: the mecal firings are on the inside,
The motal fittings on the inside,
Pedal cabie.
@ Use the ong serows
{M8 x $4 mm) to fastan the
ake bards to the pedal
board.
use two scrows for ony
aida.
@ Use the short scraws (M4 x27 mm}
te attach the center board to the
side boards,
( use two screws for each side. }
(Avoid holding the rads of the plano.)
@ Align the screws (one on each sida) located
'on the bottom of the plano with the slots
in the metal fitings on the side
boards. Slide the piano so BE
the screws stide into the <
fos. iS A
ZR @ Lit up the piano and use the two
(Note} When placing the plano on the stand, be careful not to pinch your fingers.
knob botts to fasten the piano to
the stand.
Fasten the pedal cabie with the cable clamps, and plug
in the power cable and pedal cable.
® Atfix the cable clamps on the back lett side of the stand,
Fasten the pedal cable with the cable clamps,
@ Insert he padal cable inte the pedal jack on the back panel
'of the plano.
@® Connect the power cable into the AC inlet on tho back
panei of the piano.
'The power cable is included with the piano.
+x When you finish assembling the stand, rotate the adjusting bolt unti it
touches the floor.
(Note) If the piano is placed on carpeting, rotate the adjustment bolt liste more.
(Note) When placing the piano in its location, be careful nat to pinch the power cable
underneath the plano.
unti it touches the floor.
33 LL 7