Using Cableclear ® Digital Noise Reduction; Using Mpeg Noise Reduction - Toshiba 42LZ196 Operating Manual

®
Using CableClear digital noise reduction
The CableClear ® digital noise reduction feature allows you to
reduce visible interference in your TV picture. This may be
useful when receiving a broadcast with a weak signal
(especially a Cable channel) or playing a noisy video cassette
or disc.
To change the CableClear settings:
Press Y and open the Video menu.
1
Highlight Noise Reduction and press T.
2
Video
Mode Preference
Picture Settings
Noise Reduction
Color Management Pro
Game Mode Off
Theater Settings
Navigate ENTER Select
3
In the CableClear field, select your desired setting.
Noise Reduction
CableClear
MPEG Noise Reduction
Reset
Note:
• If the current input is ANT 1, ANT 2, VIDEO 1, or
VIDEO 2, the menu will display the text "CableClear."
The available selections are Off, Auto, Low, Middle,
and High.
• If the current input is ColorStream HD1, ColorStream
HD2, or HDMI, the menu will display the text "DNR." The
available selections are Off, Auto, Low, Middle, and
High. Auto will react proportionally to the strength of
the noise. Low, Middle, and High will reduce the noise
in varying degrees, from lowest to highest, respectively.
To save the new settings, highlight Done and press T.
4
To revert to the factory defaults, highlight Reset and
press T.
56
Chapter 6: Using the TV's advanced features
CH RTN Back EXIT Exit
ANT 1
Auto
Low
Done

Using MPEG noise reduction

The MPEG noise reduction feature allows you to reduce
visible interference caused by MPEG compression. Choices
for MPEG noise reduction are Off, Low, Middle, and High.
Off is automatically selected when this feature is disabled
("grayed out").
To select the MPEG noise reduction level:
Press Y and open the Video menu.
1
Highlight Noise Reduction and press T.
2
3
Press B or b to highlight the MPEG Noise Reduction
field, and then press C or c to select either Off, Low,
Middle or High.
Noise Reduction
CableClear
MPEG Noise Reduction
Reset
To save the new settings, highlight Done and press T.
4
To revert to the factory defaults, highlight Reset and
press T.
ANT 1
Auto
Low
Done