Table of Contents
Advertisement
If the ProSense phase is
already carried out and the
water filling is already
started, the new programme
starts without repeating the
ProSense phase. The water
and the detergent are not
drained out in order to avoid
waste.
11.10 The ProSense System
load detection
After touching the Start/Pauze
1. The ProSense System starts the
laundry load detection to calculate
the real programme duration. The
indicator
and the time dots flash.
2. After about 15 minutes the display
shows the new programme duration:
the indicator
dots stops flashing.
The appliance adjusts automatically
the programme duration to the load
to achieve perfect washing results in
the minimum possible time. The
programme duration could increase
or decrease.
The ProSense System
detection is carried out with
complete washing
programmes only (no
skipping phase selected).
The ProSense System is not
available with all
programmes such as :Wol/
Zijde, Spoelen,
Centrifug.Pompen, and
programmes with short
cycles.
11.11 Opening the Lid when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the
stays on and you cannot
open the lid.
To open the lid proceed as follows:
button:
goes off and the time
indicator
1. Press the button Aan/Uit for some
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.12 Opening the Lid when
the delay start is active
While the delay start operates, the
appliance lid is locked.
To open the appliance lid:
1. Press button Start/Pauze.
The
indicator goes off.
2. Open the appliance lid.
3. Close the lid and press button Start/
Pauze.
The delay start continues.
11.13 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
comes on and the lid
locked indicator
The indicator of Start/Pauze button goes
off.
1. Press button Aan/Uit to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew
and odours
ENGLISH
21
goes off.
Advertisement
Table of Contents
