Grizzly G0638HEP Manual page 6

Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
We strongly recommend using a general-
purpose silicone sealant on all mating
surfaces during assembly process. For
those components assembled with a rubber
gasket between them, apply sealant evenly
on both sides of gasket before assembly.
-6-
(Replaces Pages 6–7 in Manual Insert)
HEAVY LIFT!
To assemble machine:
1. Connect (2) upper stand legs and (1) lower
stand brace with (4)
bolts, ⁄ " flat washers, and
5
16
(see Figure 7).
Lower Stand
Brace
Figure 7. Upper stand legs attached to lower
stand brace.
Note: To make the installation of the fasten-
ers easier, use scrap wood to raise the metal
components off the floor.
Note: Only finger tighten hardware.
IMPORTANT: Be sure to build frame using
bolt holes indicated in Figures 7–9 and 22.
Machine will not fit correctly on frame if
wrong holes are used and you will need to
rebuild frame.
2. Connect same upper stand legs and (1)
upper stand brace with (4)
riage bolts, ⁄ " flat washers, and
5
16
nuts (see Figure 8).
Upper Stand Brace
x 4
Figure 8. One side of upper stand assembled.
3. Repeat Steps 1–2 to assemble other side of
upper stand.
Model G0638HEP (Mfd. Since 7/20)
⁄ "-18 x ⁄ " carriage
5 3
16 4
⁄ "-18 hex nuts
5
16
x 4
Upper Stand
Legs
⁄ "-18 x ⁄ " car-
5 3
16 4
⁄ "-18 hex
5
16
Upper Stand
Legs