Table of Contents
Advertisement
Safety Information
Do not use the air conditioner in environments with
hazardous substances or close to equipment that
release free flames to avoid the occurrence of fires,
explosions or injuries.
Do not install the product in a place where
thermohygrostat is needed (such as server room,
machinery room, computer room, etc.) Those places do
not provide guaranteed operation condition of the product
therefore performance can be poor in these places.
Do not install the product in a ship or a vehicle (such
as a campervan). Salt, vibration or other environmental
factor may cause the product malfunction, electric
shock or fire.
Our units should be installed in compliance with the
spaces shown in the installation manual, to ensure
accessibility from both sides and allow repairs or
maintenance operations to be carried out. The unit's
components should be accessible and easy to disassemble
without endangering people and objects.
For this reason, when provisions of the installation manual
are not complied with, the cost required to access and
repair the units (in SAFETY CONDITIONS, as set out in
prevailing regulations) with harnesses, ladders, scaffolding
or any other elevation system will NOT be considered part
of the warranty and will be charged to the end customer.
Do not install the air conditioner in following places.
Place where there is mineral oil or arsenic acid. Resin
parts flame and the accessories may drop or water
may leak. The capacity of the heat exchanger may
reduce or the air conditioner may be out of order.
The place where corrosive gas such as sulphuric acid
gas generates from the vent pipe or air outlet.
The copper pipe or connection pipe may corrode and
refrigerant may leak.
The place where there is a machine that generates
electromagnetic waves. The air conditioner may not
operate normally due to control system.
The place where there is a danger of existing
combustible gas, carbon fibre or flammable dust.
The place where thinner or gasoline is handled. Gas
may leak and it may cause fire.
The place where animals may urinate on the product.
Ammonia may be generated.
The place where is close to heat sources.
Do not use the indoor unit for preservation of food
items, plants, equipment, and art works. This may
cause deterioration of their quality.
Do not install the indoor unit if it has any drainage
problem.
4
English
Power supply line, fuse or circuit breaker
WARNING
Always make sure that the power supply is compliant with
current safety standards. Always install the air conditioner
in compliance with current local safety standards.
Always verify that a suitable grounding connection is available.
Verify that the voltage and frequency of the power supply
comply with the specifications and that the installed
power is sufficient to ensure the operation of any other
domestic appliance connected to the same electric lines.
Always verify that the cut-off and protection switches
are suitably dimensioned.
Verify that the air conditioner is connected to the power
supply in accordance with the instructions provided in
the wiring diagram included in the manual.
Always verify that electric connections (cable entry, section
of leads, protections...) are compliant with the electric
specifications and with the instructions provided in the wiring
scheme. Always verify that all connections comply with the
standards applicable to the installation of air conditioners.
Devices disconnected from the power supply should
be completely disconnected in the condition of
overvoltage category.
Be sure not to perform power cable modification,
extension wiring, and multiple wire connection.
– It may cause electric shock or fire due to poor
connection, poor insulation, or current limit override.
– When extension wiring is required due to power
line damage, refer to "Step 14 Optional: Extending
the power cable" in the installation manual.
CAUTION
Make sure that you earth the cables.
Do not connect the earth wire to the gas pipe, water
pipe, lighting rod or telephone wire. If earthing is not
complete, electric shock or fire may occur.
Install the circuit breaker.
If the circuit breaker is not installed, electric shock or
fire may occur.
Make sure that the condensed water dripping from the
drain hose runs out properly and safely.
Install the power cable and communication cable of the indoor
and outdoor unit at least 1m away from the electric appliance.
Install the indoor unit away from lighting apparatus
using the ballast.
If you use the wireless remote control, reception error
may occur due to the ballast of the lighting apparatus.
Advertisement
Table of Contents
