Replacing The Belts And Brush Rolls - Bissell POWERCLEAN TURBOBRUSH PET XL Quick Start Manual

Replacing the Belts and Brush Rolls

For replacement parts, head to BISSELL.ca/parts.
1. 2.
Unplug the machine. Remove the 3 screws on
Remove both tanks. With the the brush access cover using
machine reclined, locate the a Phillips-head screwdriver.
belt access cover and lay the Remove the access cover to
machine on its side. expose the cogged belt and
brush roll.
4. 5.
Remove the brush cover by If the flat pump belt is
lifting straight up. Remove the broken, place a new belt
cogged large pump belt. The around the red area of the
brush rolls can be replaced or large pulley. Use your thumb
to stretch it toward the back
cleaned at this time, if needed.
of the machine and transfer it
onto the metal axle.
Storing Your Machine
For more helpful maintenance tips, check out support.BISSELL.ca.
Once your cleaning is complete, make sure both the Dirty and Clean Water Tanks are emptied, rinsed
out and dried before the next use. Wrap cord around cord wrap for storage. Store machine in a
protected, dry area.
NOTICE
To reduce the risk of a leaking condition, do not store unit where freezing may occur. Damage to internal
components may result.
WARNING
To reduce the risk of fi re, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
10 BISSELL.ca
Required for Maintenance
Phillips-head Screwdriver
3.
Remove the 2 screws on
the belt access cover using
a Phillips-head screwdriver.
Remove the access plate to
expose the flat pump belt. If
flat pump belt is broken, you
may gently remove it from the
machine. We will replace this
belt in Step 5.
6.
To replace the cogged
pump belt, wrap the new
belt around the small metal-
toothed pulley. While wrapped
around the pulley, stretch and
wrap around the brush gear.