Daily Use; Using The Detergent; Setting And Starting A Programme - Zanussi ZDLI1510 User Manual

DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in programme
selection mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the rinse
aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for the
type of load and the degree of soil.

USING THE DETERGENT

A B
CAUTION! Only use detergent
specifically designed for dishwashers.
1. Press the release button (B) to open the lid (C).
2. Put the detergent, in powder or tablets, in the
compartment (A).
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the release button
locks into position.

SETTING AND STARTING A PROGRAMME

Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the appliance is in
programme selection mode.
3. Press the programme button repeatedly until
the indicator of the programme you want to
select starts flashing.
4. Close the appliance door to start the
programme.
12
30
20
C
Starting a programme with delay start
1. Set a programme.
2. Press Delay Start to delay the start of the
programme of 3 hours.
• The indicator
3. Close the appliance door to start the
countdown.
When the countdown is completed, the programme
starts.
Opening the door while the appliance
operates
Opening the door while a programme is running
stops the appliance. It may affect the energy
consumption and the programme duration. After
closing the door, the appliance continues from the
point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
Do not try to close the appliance door
within 2 minutes after AirDry
automatically opens it, as this may
cause damage to the appliance.
If, afterwards, the door is closed for
another 3 minutes, the running
programme ends.
Cancelling the delay start
Press the on/off button for 3 seconds until the
appliance is in programme selection mode.
When you cancel the delay start, you have to set
the programme again.
Cancelling the programme
Press and hold the programme button for 3
seconds until the appliance is in programme
selection mode.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
The Auto Off function
This function decreases energy consumption by
deactivating automatically the appliance when it is
not operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was not started.
comes on.