Operating The Throttle; Operating The Choke; Starting The Engine - Toro TimeCutter ZR 4200T Operator's Manual

Operating the Throttle

You can move the throttle control between the F
and S positions (Figure
LOW
Always use the F position when engaging the PTO.
AST
Figure 21

Operating the Choke

Use the choke to start a cold engine.
1. Pull up the choke knob to engage the choke
before using the key switch
Note:
Ensure that you fully engage the choke.
You may need to hold the knob up when you
use the key switch.
2. Push down the choke to disengage the choke
after the engine has started
Figure 22
1. O position
N
AST
21).
g295539
(Figure 22).
(Figure 22).
g008959
2. O position
FF

Starting the Engine

Note:
A warm or hot engine may not require choking.
Important:
Do not engage the starter for more
than 5 seconds at a time. Engaging the starter
motor for more than 5 seconds can damage the
starter motor. If the engine fails to start, wait 10
seconds before operating the engine starter again.
19
Figure 23
g295541