Table of Contents
Advertisement
Important!
Note that the watch will not perform
●
auto time adjustment if it enters the
Calendar Mode while any one of the
conditions below exists.
While a stopwatch elapsed time
—
measurement or timer countdown
operation is in progress
Battery power is low.
—
Watch is in Level 2 power saving.
—
While it is too far away from its
—
paired phone
While communication is not
—
possible due to radio interference,
etc.
While the phone is updating its
—
system
Note
If the watch does not indicate the
●
correct time even if is able to connect
with a phone, correct the hand and
date indicator positions.
Adjusting Hand and Day Indicator
l
Alignment
If there is a World Time City specified
●
with CASIO WATCH+, its time will
also be synchronized automatically.
The watch will connect with the
●
phone and perform auto time
adjustment at around 12:30 a.m.,
6:30 a.m., 12:30 p.m. and 6:30 p.m.
The connection is automatically
terminated after auto time
adjustment is complete.
Summer Time
●
Once the watch is connected with a phone and
its time is adjusted with the phone time, its
Home City time and World Time will
automatically switch between standard time
and summer time as required, even if the
watch is no longer connected with the phone.
Summer Time Switching
l
Adjusting the time setting manually with a
●
watch operation will cancel auto standard
time/summer time switching.
A CASIO WATCH+ screen shows
●
information about summer time periods.
Operation Guide 5560
Triggering Immediate Time Adjustment
●
The watch will synchronize its time setting to
that of the phone immediately when they are
connected with each other. Whenever you
want to adjust the watch's time setting based
on your phone's time, perform the procedure
below to connect with a phone.
1.
X Press (C).
This causes the second hand to move to
[R]. When the watch connects with a
phone, the second hand will normally
move to e and then the watch's time
setting will synchronize with the phone's
time.
The watch will disconnect from the
●
phone automatically after time
synchronization is complete.
Configuring World Time
Settings
Specifying a World Time City with CASIO
WATCH+ causes the city's time to be
indicated by the small hour and minute hands.
Watch settings can be configured for auto
summer time switching for the World Time
City.
Note
CASIO WATCH+ World Time lets
●
you select from among
approximately 300 cities as the
World Time City.
Selecting a World Time City
●
1.
Y On the Home Screen, tap the "CASIO
WATCH+" icon.
2.
X Hold down (C) for about two seconds.
The second hand will move to [R]. Keep
●
(C) depressed until the second hand
starts moving again and completes one
full revolution, stopping again at [R].
The second hand will move from [R] to
●
e when a connection is established
between the watch and phone.
3.
Y Perform the operation shown on the
phone screen. The World Time setting will
be reflected on the watch.
The dial hour and minute hands, and the
small 24-hour hand indicate the current
time in the selected city and time zone.
You can determine whether a World
●
Time is a.m. or p.m. by checking the
position of the small 24-hour hand.
World Time hour and minute
World Time hour (24-hour)
6
Advertisement
Table of Contents
