Table of Contents
Advertisement
3 Initial operation
Setting up the device
Before installing your device, make sure that
the projector is turned off and the power cable
is unplugged from the power outlet.
CAUTION!
Remove protection foil before operating!
Do not place any objects in front of the
lens!
1 Turn the device with the rear side towards a
suitable projection surface or wall. Make sure
the projector is in a secure position.
2 Check that the projection surface is appropri-
ated to the projector. The distance between
the projector and the screen determines the
actual size of the image.
a
To change the size of the screen, just move
the projector towards or away from the wall.
The size of the screen (b) is comprised
between 0.1 and 0.42 metres depending on
the projection distance (a), as described in
the following table.
Diagonal size (b)
(mm)
[inch]
1270
[50]
3048
[120]
Initial operation
Projection distance
(a)
(mm)
108
420
Connecting power supply
CAUTION!
Always use the ] button to turn off the
projector. This is essential to allow the
necessary cooling-down time for the
UHP lamp!
1 Connect the power cable into the socket on
the rear side of your device (‚).
2 Plug the power cable to outlet
device
(ƒ).
Installing or changing the
batteries of the IR remote
control
DANGER!
Risk of explosion with incorrect type of
batteries!
Only use the AAA type battery.
1 To access the battery, press to unlock the
locking mechanism (‚) and slide out the
battery compartment (ƒ).
2 Insert the new batteries into the battery com-
partment with the positive and negative
near the
a
b
11
Advertisement
Table of Contents
