Table of Contents
Advertisement
3 Initial Operation
Setting up the Device
You can position the device so that it lies flat on a table
in front of the projection surface; it is not necessary to
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection
(pincushion distortion).
Connect Power Supply /
Charge Battery
CAUTION!
Mains Voltage at the Site of Installation!
Check whether the mains voltage of the
power supply matches the mains voltage avail-
able at the setup location.
1 Insert the small plug of the power supply into the
socket on the rear side of your device.
2 Plug the power supply into the mains.
3 During the charging process, the indicator light on
the side of the device will be red. When the battery
is fully charged, it will turn green.
4 Charge the built-in battery completely before using
for the first time. This will prolong the life of the bat-
tery.
Notice
Pico Station
The battery of the Pico Station will not be
charged while the projector is in use.
Notice
Charging via Pico Station
The battery of the projector will not be
charged while the projector is in use.
Notice
Operate via Pico Station
The battery of the Pocket Projector is empty:
Connect the Pico Station to use the Pocket
Projector.
11
Notice
Battery Empty
The battery of the Pocket Projector is empty:
Connect the Pico Station or the power supply
to use the Pocket Projector.
Connect the power supply to the Pocket Pro-
jector or the Pico Station to recharge the bat-
tery.
Disconnect the power supply only if the
Pocket Projector is sufficiently charged. Oth-
erwise the Pocket Projector turns off.
Installing or Changing the
Batteries of the Remote
Control
DANGER!
Risk of Explosion with Incorrect Type of
Batteries
Only use the CR 2025 type battery.
There is a risk of explosion if the incor-
rect battery type is used.
1 To access the battery, disengage the locking mecha-
nism (1) and slide out the battery compartment
(2).
Philips · PPX3614
Advertisement
Table of Contents
