Table of Contents
Advertisement
3.5.3.4 Level of assistance
The higher the level of assistance, the more the
drive system assists the rider when pedalling.
eMTB mode is available for Performance Line CX
drives. In eMTB mode, the assistance factor and
the torque are dynamically adjusted depending on
the pedalling force applied to the pedals. If the
pedelec has been configured with "eMTB mode",
"eMTB mode" appears briefly when the SPORT
level of assistance is selected.
Level of assistance
Use
O F F
When the drive system is switched on,
the motor assistance is switched off.
The pedelec can be used like a normal
bicycle by simply pedalling. The push
assist system cannot be activated.
EC O
Limited assistance with maximum
efficiency for maximum range
T O UR
Constant assistance, for long-range
tours
e
S P O R T /
M T B
SPORT
Powerful assistance for sport rides on
mountainous routes and on urban roads
e
Optimum assistance on any terrain,
M T B
sporty start-up, improved dynamics and
available in
maximum performance
combination with
motors: BDU250P
CX, BDU365,
BDU450 CX and
BDU480 CX motors
T UR BO
Maximum assistance up to high
pedalling frequencies, for sport riding
Table 26: Overview of levels of assistance
3.5.4
System message
The drive system monitors itself continuously and
if an error is detected, it is indicated by a system
message. The system may switch off
automatically depending on the type of error.
There is a table of all system messages in
Section 6.2. You will find assistance for system
messages in Section 8.5 Initial help.
MY21K01 - 32_1.0_23.09.2020
All manuals and user guides at all-guides.com
3.5.5
ABS indicator lamp
The anti-blocking system indicator lamp must light
up after the system has started up and must go
out once speed has reached about 5 km/h. If the
ABS indicator lamp does not light up when the
electric drive system starts, the ABS is defective.
An error code on the display screen also tells the
rider that it is defective.
If the indicator lamp does not go out after you set
off or it lights up while you are riding, this means
there is an error in the anti-blocking system. The
anti-blocking system is then no longer active. The
brake system itself remains functional. It is only
the anti-blocking system control which no longer
operates.
If the ABS indicator lamp is lit, the ABS function is
not active.
Notice
The anti-blocking system indicator lamp may light
up if the front and rear wheels are rotating at
widely different speeds from one another – for
example, if the rider cycles on the rear wheel only
or if a wheel is rotating for a unusually long time
without making contact with the ground (fitting
stand). The anti-blocking system switches off in
such cases.
Note: You need to stop and restart the pedelec
(switch off and on again) to reactivate the anti-
blocking system.
Overview
35
Advertisement
Table of Contents
