Table of Contents
Advertisement
Turn the twist grip (1) backwards to switch up
a gear (4).
Turn the twist grip (1) forwards to switch down
a gear (2).
The gear shift switches the gear.
The screen display (3) shows the changed
gear.
6.17.3 Using eShift
Only applies to pedelecs with this equipment
eShift refers to the integration of electronic gear
shift systems into the electric drive system.
6.17.3.1 eShift with Shimano DI2 automatic hub
gears
Only applies to pedelecs with this equipment
The automatic Shimano DI2 hub gear can be used
in manual or automatic mode. Use the shifter to
change gears in manual mode. In automatic
mode, the shift system changes gear
automatically depending on the speed, pedalling
power and pedalling frequency. You will find how
to switch from automatic to manual mode,
depending on the shifter used, described in your
operating instructions on the display screen. If you
use the shifter when in automatic mode, the gear
system will change to the next gear and it will
remain in automatic mode. Manual gear changes
in automatic mode influence shift behaviour in the
gear system and adjust gear changes to riding
performance. If the system is switched on for the
first time when a new, unused wheel is used, the
system will learn the gears first. To do so, the
automatic system changes to the highest/most
difficult gear and then switches through all gears
during the first ride. The new gear is shown briefly
on the display screen each time it is changed.
Since the motor detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
If the pedelec is brought to a halt from a speed
greater than 10 km/h, the system can
automatically switch back to a pre-set S TA R T
G E A R .
Set the S T A R T G E A R in the system settings
if necessary.
MY21K01 - 32_1.0_23.09.2020
All manuals and user guides at all-guides.com
6.17.3.2 eShift with manual Shimano DI2 hub
gears
Only applies to pedelecs with this equipment
The new gear is shown briefly on the display
screen each time it is changed.
Since the motor detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
If the pedelec is brought to a halt from a speed
greater than 10 km/h, the system can
automatically switch back to a pre-set S TA R T
G E A R .
Set the S TA R T G E A R in the system settings
if necessary.
6.17.3.3 eShift with Shimano DI2 automatic hub
gears
Only applies to pedelecs with this equipment
Since the motor detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
The new gear is shown briefly on the display
screen each time it is changed.
Operation
92
Advertisement
Table of Contents
