WORK
Installing the start number plate
3.3
Removing the seat
3.4
Mounting the seat
3.5
Installing the battery
3.6
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Make sure that the holding lugs engage in the fender.
–
Position the brake line and clamp. Mount and tighten screw
101278-11
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
101279-10
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower it at the
rear and simultaneously it push forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixation.
Guideline
Remaining screws, chassis
B00318-01
Main work
–
Place the battery in the battery holder.
(All SX‑F models)
Battery (YTX4L-BS)
(250 XC-F USA)
Battery (YTX5L-BS)
–
Reconnect rubber band
–
Attach the positive cable and replace the positive terminal cover
101086-11
–
Attach negative cable
Subsequent work
–
Mount the seat. (
M6
.
1
M6
.
1
.
3
p. 7)
7
.
1
10 Nm (7.4 lbf ft)
.
2
10 Nm (7.4 lbf ft)
.
2