SETUP
7
7
7
0 0 7
8
0 0 8
8
0 0 8
–
Position FI warning lamp with holder
Guideline
Remaining screws, chassis
–
Attach connector
–
Mount cable holder
B00534-10
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp
Screw, bottom triple clamp
B00535-10
Info
The topmost milled groove in the fork leg must be flush with the top
edge of the upper triple clamp.
Position bleeder screws
–
Remove screws
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten
screws
.
8
Guideline
Screw, handlebar support
Info
B00375-11
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp
101020-10
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
101017-01
. Mount and tighten screw.
3
to the wiring harness.
4
to the frame.
5
toward the front.
6
. Take off the handlebar clamps.
7
. Remove the handlebar supports.
8
M10
M8
M6
10 Nm
(7.4 lbf ft)
M8
17 Nm
(12.5 lbf ft)
M8
12 Nm
(8.9 lbf ft)
Loctite
®
243™
40 Nm
(29.5 lbf ft)
20 Nm
(14.8 lbf ft)
4