Display Assembly; Removing The Display Assembly - Dell 0HRTG Service Manual

Steps
1. Reconnect the touchpad FFC to the touchpad module.
2. Align and place the touchpad module onto the system.
3. Install the two (M2x2) screws to secure the touchpad module to the palmrest.
4. Install the touchpad bracket on the touchpad and secure it using the three (M2x2) screws.
5. Peel back the conductive tape over the touchpad module.
6. Reconnect the touchpad FFC to the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in

Display assembly

Removing the display assembly

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Disconnect the battery
5. Remove the WLAN.
after working inside your
before working inside your
cable.
computer.
computer.
Disassembly and reassembly 51