Table of Contents
Advertisement
. Follow the instructions under "Install the conduit as
follows" on page 7 to correctly install the strain
relief.
DO NOT install the conduit without a strain relief.
. Loosen the 2 lower left and right screws from the
terminal block. (Refer to Figure 12.)
Remove the lower 2 center screws.
. Remove ground strap and discard as shown
in Figure 12.
Do not discard any screws.
. Attach the ground bare wire end to range frame
and secure it in place with the ground screw (Refer
to figure 12.)
. Insert the bare wire (white/neutral) end through the
center terminal block opening.
. Insert the two side bare wire ends into the left and
the right terminal block opening.
Tighten the 3 screws securely into the terminal
block. (approximately 35 - 50 IN-LB)
. Go to page 10.
-
4-wire connection
Black
White
Red
Wire ends
Remove ground
strap
and discard
Conduit
connection plate
FIGURE 12
Advertisement
Table of Contents
